Click on the Devices and Printers applet.Ĥ. If your Category view looks like this, click the View By dropdown and select Small Icons. Click on the applet when you see it or press your Enter key.Ģ. Click your Start Menu and then type Control Panel. How your Tag Printer driver settings should lookġ. If for any reason you ever need to roll the tags up, make sure that you hit the feed button twice, if you do not turn the printer off. Rolling up the tags will break this alignment.

This procedure is required in order for the tag printer to align your tags. Note: Do not roll the tags back up into the printer.

The printer will now automatically Calibrate your tags and read the proper gap size and height. In the case of jewelry tags, make sure that at least one whole tag is sticking outside of the printer.ġ3. Make sure that at least half a tag is sticking out of the printer. Use the green turn dial on the right to adjust the black guide arms so that they are snug up against the tags.ġ2. Then place the spindle with the roll back into the printer. Reassemble the spindle with the roll placed as close to the center as possible. Point the red straw and blow out the center cavity first, then blow out the plastic gear on the left and finally blow out the center crevices near the sensor.ġ1. Note: Please make sure that the Thermal Head is dry before using the printer again. Do not use 70% alcohol as the additives could damage your tag printer’s thermal head over time. Note: The higher the percentage of alcohol, the better it will be for cleaning your printer head. Do not pour or spray alcohol directly on to any of the printer parts, only pour or spray on the microfiber rag. Using a clean and dry Microfiber Rag and 91% to 99% Isopropyl Alcohol, clean the TSC tag printer’s Thermal Head. Note: Please make sure that Black Rubber Roller is dry before using the printer again.Ĩ. Place the Black Rubber Roller back into position on the tag printer and gently press down on both sides to snap the clips back into position. Take a Microfiber Rag with some Water and clean off the Black Rubber Roller. Pinch the two clips on both sides of the roller gently, and then lift the roller up.Ħ. Next, you will need to remove the Black Rubber Roller from it’s housing.

Adjust the green Gap Sensor so that the plastic arrows are between the Black Rectangle and the Circle sensor.ĥ. Remove the tag roll completely from the printer, disassemble the spindle and set it aside.Ĥ. Open the tag printer lid by pulling up on the green tabs on the left and right of the printer.ģ. Most printing issues encountered with the TSC TDP-247/TDP-245 Plus tag printer can be resolved by doing the following:Ģ. If your tags are printing in between two tags, please click on the following link to skip to the appropriate section that addresses this issue: How Your Tag Printer Driver Settings Should Look Troubleshooting The TSC TDP-247/TDP-245 Plus Tag Printer

Tsc tdp-245